Screw the push button in a spot of your preference. It doesn’t matter what side the red or white go onto. Put the one-button wire around the post and tighten the screw down on them. Loosen the screws on the two terminal posts, take the supplied bell wire and separate the red and white wire. Next remove the tab so you can run wire through the it. These wires will go into either of the two green connections. You will again want to staple the wire on the jam to the operator. This is installed to keep tension on the cable while in the fully up position. You want to screw the cable tensioner 3-4 inches from where the cable comes off the drum. Once the wires are together, put the black wires into the black connector and the white wires into the white connector on the operator. Connect both the black wires together and the white wires together that are coming from the safety eyes. Open the cover of the operator to reveal where the connections will be made. Repeat this process on the other side of the door with the other mount, safety eye and wire. Secure the wire up the jam with staples and make sure to leave slack before the first staple so that in case the safety eye gets bumped or moved, the wire will not rip. Run the bell wire from the safety eye up to the operator.

Remember: Make sure to extend the eye past the farthest part of the door. The bracket slides onto the bolt, is secured with a wing nut, and will now attach to the mount we just put in. There is a groove on the back of the safety eye where you can put the bolt that attaches to the bracket. Pro Tip: Use the first jam bracket as a guide to line them up horizontally. You want them about 6-10 inches from the ground. Start by securing the mount to the jam at the bottom of the garage door. Finally, fasten the screws to the wall and tighten the screws on the operator. Fasten the wall mount to the wall or jam and make sure your operator is level vertically. Then, mount the operator to the torsion bar. Make sure not to tighten the wall bracket all the way down so you can adjust and level it on the wall later. Next, attach the wall bracket to the operator. Start by attaching the shaft collar to the shaft of the operator.

Instaling Jack Move